![Should I add internal thread to the hole or is there a way to use the screw I made as a cut out of the internal thread? Tried printing by adding internal Should I add internal thread to the hole or is there a way to use the screw I made as a cut out of the internal thread? Tried printing by adding internal](https://preview.redd.it/should-i-add-internal-thread-to-the-hole-or-is-there-a-way-v0-episzwyk7pmb1.png?width=640&crop=smart&auto=webp&s=6d6cdb95f9da39981d5d5d691650de709f9e4a82)
Should I add internal thread to the hole or is there a way to use the screw I made as a cut out of the internal thread? Tried printing by adding internal
Solved: Getting a New Hole to Align with an Existing Hole ( with 2 separate components)... - Autodesk Community - Fusion
![Beginner] Holes are too small, but the rest is normally sized - Troubleshooting - V1 Engineering Forum Beginner] Holes are too small, but the rest is normally sized - Troubleshooting - V1 Engineering Forum](https://us2.dh-cdn.net/uploads/db5587/original/3X/f/9/f90b883a3778947cbc4447206c08adcec7cde194.png)